![]() If you can't free the wings inside the wall, remove the bolt and let the toggle fall away and try again with another anchor. Pull back on the bolt again to be sure neither toggle wing is folded back against the bolt. If you can see the end of a toggle wing coming back out of the hole, push the bolt head back flat again and jiggle it or turn it slightly one way or the other to shake the toggle wing free. Pull the bolt back to be sure the toggle has completely opened and has engaged the wall. Pinch the toggle arms together and push the whole assembly into the hole pushing on the bolt head completely flat with the wall until the toggle springs open inside. Drill a hole large enough to pass the toggle hinge. Remove the toggle and install any wall brackets before inserting it into the wall. These will not hold as much weight in a ceiling and should only be used for very light duty if at all in those cases. These are intended for light loads up to about 30lb when used in hollow walls, to heavy loads of about 100lb when used in solid masonry walls. As a screw is threaded into the sleeve, it spreads slightly to press against the sides of the hole. The anchor is driven into a slightly undersized, pre-drilled hole. They are also good for solid materials like concrete and brick. These can be used in solid and hollow wall materials including: drywall, plaster, and paneling. Use these for hanging small shelves, mirrors, and wall art. For instance, a shelf support may tend to pull out on the hanger while a mirror will pull straight down, making a shelf less secure than a mirror of the same weight. The type of installation will also have a bearing on load capacity. As a general rule, hollow walls like drywall and paneling will hold less weight than solid walls like concrete and some plasters using the same anchor. Be sure anchors are installed correctly and firmly for full benefit. The load capacities for the wall anchors in these charts are approximate. Use one that will safely support the weight of the object to be suspended. ![]() These anchors come in three basic types: sleeve, toggle, and expansion. This page contains pictures, descriptions, and load ratings for the most commonly available wall anchors for drywall, plaster, and masonry, including solid and hollow walls and ceilings.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |